EGT303 Software tools support page

Automation SDK

Fully supported. See the Automation SDK page

GUI (Graphical User Interface)

Manual control monitoring and logging. Log file will be stored at C:\Users\USERNAME\Documents\EGT303_Log EGT303 GUI
Licence conditions are attached to the use of this software

Logging Software

To be added

Command Terminal

Send and receive raw ASCII commands on the serial port for manual control and monitoring. See CmdTerm2
Licence conditions are attached to the use of this software
Download the button files (to be added)
NOTE: Consider the Automation SDK as your primary method of control

Firmware update tool

Update the firmware on your PSU. New firmware issued in response to a support request. PsuLoader (firmware update tool) - - > > (Instructions - Note: In 'Connect' menu, select EGT303 (not EG353)
Licence conditions are attached to the use of this software

Serial to optical interface

Use AE Part number 33400218-00 to connect your PC to the PSU.

Step by Step instructions

Connect to the USB socket of your computer
Wait. Windows 7 (and above) will automatically install drivers from windows update
For Linux or offline driver installation, visit FTDI
Connect as shown in photographs below
Start the GUI software and select the newly created COM port

Connection Troubleshooting

To disconnect - NEVER pull on the fibre cable. Grip the connector tightly and remove. Visually inspect the ends of the fibre optic cable. Check the plastic fibre is flush with the end tip of the connector and not pulled inside the body of the connector. This is the most common cause of connection problems.